By Alkesh Gorsia CEng MIET, ILP registered · Updated November 2026
All UK bat species and their roosts are legally protected. Artificial light at night can disturb bats, delay them leaving roosts, block commuting routes and reduce the insects they feed on. That's why ecologists and councils pay close attention to lighting on sites near trees, hedgerows, rivers, ponds and older buildings.
The key reference is Guidance Note 08/23: Bats and Artificial Lighting at Night, published by the Institution of Lighting Professionals with the Bat Conservation Trust. If your ecology report mentions bats, the council will expect your lighting to follow it.
The approach in GN08/23
The guidance sets out a step-by-step process. In practice it works like this:
- Identify bat habitats and features on and around the site, using the ecologist's surveys.
- Decide which features are important: roosts, commuting routes such as hedgerows and tree lines, and foraging areas.
- Design the lighting to avoid lighting those features, and use the least light needed.
- Demonstrate it with lighting calculations and lux contour plans showing light levels at the sensitive features, both on the ground and on vertical surfaces such as hedgerows and roost entrances.
- Make sure it is installed and maintained as designed.
Bat-sensitive lighting design measures
- Avoid lighting where it isn't needed. The best bat-friendly light is no light.
- Warm colour temperature: 2700K or lower, with no ultraviolet content. Some sites need amber sources.
- Fully shielded fittings with no light above the horizontal.
- Low mounting heights, such as bollards and low-level wall lights instead of tall columns, where safe.
- Accessories such as shields, louvres and cowls to cut light spill towards hedgerows and trees.
- Dark buffer zones along key commuting routes, kept free of direct and spill light.
- Controls: motion sensors, timers, dimming and part-night switching.
Get an instant fixed price using LuxQuotesAnswer a few questions and see your fixed price in about a minute.
Get my fixed priceWhat the ecologist will look for
The ecologist will check that your lux contour plan shows light levels near zero along the features they identified. Typical comments on submissions that fall short include light spilling into a hedgerow buffer, cool white fittings, or no vertical illuminance check on a roost entrance. Getting the design right first time avoids repeated rounds of comments.
Bat-sensitive lighting assessments from LuxQuotes
When you tick "Bats or wildlife" in our quote, we design your scheme to GN08/23 and model light levels at the features in your ecology report. Send us the ecology report with your drawings. Get an instant fixed price using LuxQuotes.
Frequently asked questions
What colour temperature is best for bats?
Warm white light with little or no blue content is recommended near bat habitats. Fittings of 2700K or lower are a common requirement, and some ecologists ask for amber or 2200K sources in the most sensitive locations.
Can I have any lighting near a bat roost?
Usually yes, but it must be carefully designed. Roost entrances, flight lines and key foraging areas should be kept dark, normally shown on a lux contour plan with light levels near zero at those features.
Does the lighting designer or the ecologist decide?
Both. The ecologist identifies which habitats and features need protecting. The lighting designer designs a scheme that keeps them dark and proves it with calculations. The best results come when the two work together.
Get an instant fixed price using LuxQuotesAnswer a few questions and see your fixed price in about a minute.
Get my fixed price